Panel Mounting; Wall Mounting - Carel DLOGNTC015 Manual De Utilización

Introduction
Carel presents a new range of Dataloggers in compliance with the 89/108/EEC, 92/2/EEC directives that
order the recording and storage of the data regarding the deep-frozen food temperatures for at least one year.
The Datalogger of the Carel range is an electrical device offered in various models, that can monitor and
record data read by two or four temperature probes. In this manual we present the two-channel model.
Kit
Description of the kit content: 1 Datalogger, 1 manual, 1 calibration certificate, 1 manufacturer's guarantee,
1 small bag containing 5 screws, packing. The probes are sold separately. The use of Carel code
DLOGNTC015 probes is suggested.
Mounting
The Datalogger can be both panel or wall mounted.

Panel mounting

• Make a hole in the panel with the following dimensions: 182x153mm.
• Unscrew the two frontal screws (see a, b) and take out the central door (c).
• Unscrew the two screws (d, e) that keep connected the lower and frontal cover of the Datalogger and
separate the two parts.
• Make two holes in the back part (in the perforated part- f, g).
• Join the back part and the front, with the panel in between, and fix the whole with the two screws
(dimensions: 4x10mm) that are contained in the kit.
N.B. It is necessary to remove the two upper fixing teeth (h) of the frontal part before the panel insertion.
Make the hole in the back upper (l) or lower part (i) to allow the cable passage. The pitches of the establi-
shed threads ranges from PG9 (diameter: 16mm) to PG21 (diameter: 29mm). In order to make easier the dril-
ling operation, the use of a drill and a cutter is suggested. Connect the cables to the terminal block. Screw
again the screws (d, e). Then screw the door (c).

Wall mounting

• Unscrew the two frontal screws (see a, b) and remove the central door (c).
• Unscrew the two screws (d, e) that keep connected the lower and frontal cover of the Datalogger and
separate the two parts.
• Once decided where to pass the cable duct or the cables (from above or from below) and then after making
the proper holes (in the part drilled in advance - i, l) for cablepresses and pipepresses, make three holes
(m, n, o) both in the Datalogger and in the wall itself.
• Insert the "wall" nugs, contained in the kit, into the holes made in the wall and then fix the back part of the
Datalogger with the three screws (m, n, o) and the relevant Orings to the wall itself.
• Afterwards, fix the cablepresses or pipepresses before mounting the frontal part of the Datalogger.
• Subsequently, mount the frontal part, being careful with the positioning of the upper teeth (h) and the proper
fixing of the two screws (d, e) (do not press excessively in order to avoid plastic deformation).
• Only after the connection of the cables to the terminal block, the door can be shut again.
Attention: After the wiring fix the cables by the proper cable-tie.
26
sensor 1 sensor 2
d
a
c
upper part
120
m
n
back
side
g
f
o
i
lower part
27
h
i
l
e
b
l