Technical Specifications; Maintenance And Cleaning Schedule - ATIKA BAE 30 Manual Original

Maintenance work
Fuelling
Lubricate the gearbox
Check the cutting blade
Replace the cutting blade
Check the thread spool
Replace the thread spool
Replace the thread knife
Adjust the cutting device
Lubricate the cutting device
Check the guide bar
- Clean/turn round
- Replace
Check the chain wheel
- Have it replaced
Check the saw chain tension
Check the saw chain
- Have it sharpened
- Replace
Check the chain lubrication
Clean the oil tank
Throttle trigger / throttle lock-out
switch / ON/OFF switch –
Functional test
Throttle trigger / throttle lock-out
switch / ON/OFF switch –
Have it replaced
Cranking rope - Functional test
Cranking rope
Have it replaced
Check the fuel and oil tank caps
Replace
Clean fuel filling filter
Clean the fuel filter
Replace air filter
Cleaning the air filter
Replace air filter
Spark plug
Check the spark plug connector
Replace the spark plug
Clean the silencer
Check the carburetor in idle speed
(cutting tool may not move)
Have this adjusted
Check the machine
Clean the machine
Replace the safety label
38
M a i n t e n a n c e a n d
M a i n t e n a n c e a n d
Before After
each use each use
c l e a n i n g s c h e d u l e
c l e a n i n g s c h e d u l e
Every Every
8 Std. 25 Std.
Every 100 If
hours required /
damaged
Each
season