Operating This Unit; Basic Operations; Turning The Unit On And Selecting A; Source - Pioneer DEH-2800MPB Manual De Operación

Section
03

Operating this unit

Basic Operations

Turning the unit on and
selecting a source
You can select a source you want to listen to.
To switch to the built-in CD player, load a disc
in the unit (refer to page 10).
% Press SOURCE to select a source.
Press SOURCE repeatedly to switch between
the following sources:
Built-in CD playerTuner
When you select a source, the unit is turned
on.
Notes
! When no disc has been set in the unit, the
source will not switch to the built-in CD player.
! When this units blue/white lead is connected
to the vehicles auto-antenna relay control
terminal, the vehicles antenna extends when
this units source is turned on. To retract the
antenna, turn the source off.

Adjusting the volume

% Use VOLUME to adjust the sound level.

Turning the unit off

% Press SOURCE and hold until the unit
turns off.
6
En

Tuner

Listening to the radio

1 2
This units AF (alternative frequencies search)
function can be turned on and off. AF should
be off for normal tuning operation (refer to
page 8).
1 Band indicator
Shows which band the radio is tuned to,
MW/LW or FM.
2 LOC indicator
Shows when local seek tuning is on.
3 Stereo (5) indicator
Shows when the selected frequency is
being broadcast in stereo.
4 Frequency indicator
Shows the frequency to which the tuner is
tuned.
5 Preset number indicator
Shows which preset has been selected.
1 Press SOURCE to select the tuner.
2 Press BAND to select a band.
Press BAND until the desired band (F1, F2 for
FM or MW/LW) is displayed.
3 To perform manual tuning, briefly press
c or d.
4 To perform seek tuning, press and hold
c or d for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by briefly pressing
c or d.
3 4 5