Using The Machine; Adjusting The Movement Direction - Ghibli & Wirbel ROUND 45 TOUCH Instrucciones De Uso Y Mantenimiento

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
Use the appropriate controls to activate
the drive mechanism, if available for the
model in use.
Brushing only cycle:
- To perform only the brushing cycle, press
the button (52 Fig. 9) to enable brush ro-
tation.
Touch the touch sensor to start the rota-
tion of the brush/es (for models with inte-
grated traction it also starts traction).
Washing, brushing cycle:
- Press the button (52 Fig. 9) to enable
brush rotation, press the button (51 Fig.
9) to enable water dispensing.
Touch the touch sensor to start the rota-
tion of the brush/es and the water supply
(for models with integrated traction it also
starts traction).
Washing, brushing, drying cycle:
- Press the button (50 Fig. 9) to start the
aspirator, button (52 Fig. 9) to enable
brush rotation and press the button (51
Fig. 9) to enable water dispensing.
Touch the touch sensor to start the rota-
tion of the brush/es and the water supply
(for models with integrated traction it also
starts traction).
10.1.c - Using the machine (Fig. 1)
- After starting the machine and choosing
the type of cycle, start cleaning, by push-
ing the machine using the handle (1 Fig.
1) or by touching the touch sensor (20
Fig. 1), to start the drive (for models with).
NOTE:
Pay attention to particularly delicate floors;
do not use the machine while it's stopped
and the brush rotation on.
For particularly dirty spots, adjust the traction
speed to "0" so the brush will rotate in the same
position, without straining the traction motor.
NOTE:
The proper cleaning and drying of the floor
is done by pushing the machine forwards;
if you go backwards the machine will not
perform drying; in this phase, always lift the
wiper to avoid damaging the blades.
- Adjust the traction speed (if present) as
shown above.
- If necessary, adjust the amount of wash-
ing water through the button (51 Fig. 9).
- If necessary, adjust the amount of chemi-
cal agent (optional) with the help of the
button (49 Fig. 9).
- Check the battery charge status on the
display.
NOTE:
After 3 minutes of inactivity the machine
shuts off automatically.
10.1.d - Adjusting the movement
direction (only for version
45D55) (Fig. 14)
If during the cleaning operation (rotating
brushes) we notice that the machine is not
moving in a straight line, but tends to go left
or right, you can adjust the direction of the
wheels (78).
- Start the machine and begin the rotation
of the brushes.
If the car tends to go to the right, gently
turn the wheel button (78) to "S" until the
direction is right;
If the car tends to go to the left, gently
rotate the wheel button (78) to "D" until
the direction is right.
ENGLISH - 13