Camera-Type-Dependent Functions - Leica SF 40 Instrucciones

Notes:
• The descriptions in this manual are largely limited to use of the
Leica SF 40 and with Leica cameras of currently available series.
• In this manual, only those functions are described that the user
sets himself/herself on the flash unit. With a few exceptions,
this also applies to displays on the flash unit.
Please therefore follow the notes on flash operation in the
manual of the camera used, in particular which flash functions
are supported by your camera, as well as those referring to the
flash-related settings on the camera and, if available, the
camera's own flash-related displays.
CAMERA TYPE-DEPENDENT FUNCTIONS
The flash functions listed below are available (sometimes
depending on the equipment of the camera system used).
– Flash readiness display in the camera viewfinder/on the monitor
– Automatic flash synchronization control
– TTL flash mode
– Automatic fill-in flash control
– Manual flash exposure compensation
– Synchronization to the start of the end of the exposure time
(setting on the camera)
– Automatic high-speed synchronization with
– Automatic control of the zoom reflector
– Preflash function to reduce the "red-eye effect" (setting on the
camera)
– Wireless release for flash operation remote from the camera
– Permanent light for video shots
– Automatic switch-off function
Note:
When using lenses or cameras that do not allow any data transfer
between each other, i.e. that do not have any relevant interfaces in
the bayonet, there may be some restrictions to function.
EN
27