Operation - Bartscher 109470 Instrucciones De Servicio

Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid specification should
be compared with that of the device (see rating plate). Connect the device only
in case of compliance!
Connect the device only to properly installed single socket with
protective terminal.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.

5.2 Operation

•
Before first use, clean the device according to the instructions in 6 „Cleaning".
•
Prior to first use, wash by hand the polishing head cloths in warm water with a neutral
cleaning agent. Rinse them thoroughly in clean water and dry at room temperature.
Installing the polishing head cloths
•
Place the polishing head cloths on the heads. Remember to place the interior glass
polishing head cloth on the middle head, and the larger ones place on any of the
remaining 4 heads.
Polishing glasses
CAUTION!
Only polish clean glasses.
Only wash glasses at temperatures below 70 ° C!
•
Connect the unit to a grounded single socket.
•
To turn the unit on, put the ON / OFF switch in the position marked „I". To turn the
unit off when in use, put the switch in the position marked „O".
•
Before using, let the unit heat up for approx. 15 minutes.
•
Glasses must be wet for them to be polished.
- 25 -