Cleaning And Maintenance - Bartscher 109470 Instrucciones De Servicio

•
The microfibre cloths absorb moisture in a few seconds, which is why the cloths are
dried by having hot air blown on them. This keeps the polishing head cloths
constantly dry.
WARNING! Risk of injury!
To avoid injury, do not bring your hands near the hot air exhaust.
•
Take a wet and washed glass and proceed as follows:
Glasses with bases should have the bases dried first. Hold the bottom
of the glass against a polishing cloth.
Turn the glass and move the glass base between the polishing heads, turning
it vertically back and forth to ensure the entire base is dried and polished.
At the end, place the glass on one of the polishing cloth heads; the interior
of the glass and its base are dried immediately. The exterior is dried by
contact with the other four polishing heads.
•
Turn the unit off using the ON / OFF switch and remove the plug if the unit is not
to be used any longer.
CAUTION!
To avoid overheating, turn the unit off after 2 hours of work
and leave to cool for 5 minutes.
6. Cleaning
CAUTION!
Before cleaning, disconnect the device from the power supply
(pull the plug out of the socket!).
The device is not suited for direct washing with water jets. Therefore,
you must not use any kind of pressure water jet for cleaning the device!
Make sure no water gets into the device.
o Clean the unit regularly.
o Wash the housing with a moist, soft cloth. If necessary, use a mild cleaning agent.
- 26 -