Setup; Unit Placement And Softgoods Installation - Chattanooga Group OptiFlex 3 2090 Manual De Usuario

SETUP

UNIT PLACEMENT AND SOFTGOODS INSTALLATION

1. Place the unit on a level surface.
•
Place the unit on a level surface. Use of the unit on unstable
surfaces do not give the stability the unit requires. If the unit
becomes unstable, serious injury to the patient may occur.
•
The Softgoods Kit is for single patient use only. A new Softgoods
Kit must be used for each new patient.
•
Make certain that the unit is electrically grounded by connecting
only to a grounded electrical service receptacle conforming to the
applicable national and local electrical codes.
2. Install the Softgoods Kit to the carriage of the OptiFlex 3. Use the
installation instructions packaged with the Softgoods kit.
•
Chattanooga Group Softgoods Kit (Part Number 20533) is
designed specifically for the OptiFlex 3 unit. Attempted use of any
other brand of CPM Softgoods Kit may cause malfunction of the
unit and injury or discomfort to the patient.
3. Plug the unit into an approved grounded outlet. Turn the power on.
OptiFlex® 3 Continuous Passive Motion (CPM) Therapy Unit
13