Assembly; Start Up - Truper COMP-AERO Manual Del Usario

Assembly

• Before operating the compressor, double check is set on
1
a flat, leveled and solid surface, with good ventilation and
away from flammable objects like drapes, etc.
• Keep at least 12" free space around the compressor to
allow air to flow.
1• Connect the power cord into the power outlet. Make
sure it is not damaged or turned into an obstacle a
tripping hazard.
2• Connect the end of the air hose (Not included) to the
compressor air outlet. (1)
3• Connect the other end of the air hose to the air brush
inlet (Not included). (2)
4• Press the power switch into the "I" position to switch on
2
the compressor. Check there are no leaks in the air
Air Brush AERO-35
connections.
(not included)
• Turn off the compressor to repair any leak detected.

Start Up

CAUTION Use this compressor only with an air
brush. Do not use it with any other type of painting
A
equipment.
• Connect the plug into the power source.
• Press the switch into the "I" position to start the
compressor.
B
• Adjust air pressure lifting the pressure regulator (A) to
un-block it. Turn it until getting the desired pressure
indicated in the gauge (B). Then, press the regulator
downwards to block it back.
• When finishing using the compressor, set the switch into
the "O" position (off). Release the air remaining inside and
disconnect the air brush.
• Carry out maintenance in the air brush following the
manufacturer instructions.
Note: The compressor will automatically switch off if hot
A
in excess, or if overloaded. In this case, press the switch
into the "O" position and wait for it to cool down before
starting it again.
ENGLISH
7