Assembly - Shindaiwa C242/EVC Manual Del Proprietário

Assembly

This unit comes fully assembled with the
exception of the handlebar, cutting attach-
ment shield and cutting attachment.
IMPORTANT!
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front"
and "rear" refer to directions as viewed by
the operator during normal operation.
Handlebar
Install the handlebar:
1. Use the 4 mm hex wrench to remove
the lower cap retaining screws from
the handlebar bracket. Remove the cap
from the bracket, and note the position
of the two spacers installed between the
bracket halves.
2. Position the handle on the outer tube
forward of Handle Positioning Label as
shown. Reassemble the lower cap to the
handlebar bracket in the reverse order
of disassembly.
3. Locate the handle in the best position
for operator comfort.
4. Firmly tighten both lower cap retaining
screws.
Adjust throttle lever free play
The throttle lever free play should be
approximately 4-6 mm. Make sure that
the throttle lever operates smoothly
without binding. If it becomes necessary
to adjust the lever free play, follow the
procedures and illustrations that follow.
1. Loosen the air cleaner cover knob and
remove the air cleaner cover.
2. Loosen the lock nut on the cable
adjuster.
3. Turn the cable adjuster in or out as
required to obtain proper free play.
4. Tighten the locknut.
5. Reinstall the air cleaner cover.
6
Prior to Assembly
Before assembling, make sure you
have all the components required for a
complete unit and inspect unit and compo-
nents for any damage.
Engine/Outer tube assembly
Handlebar and Throttle assembly
Cutting attachment shield
Cutting attachment
Handlebar
Outer Tube
Lower Cap
Retaining Screws
Mounting the brushcutter handlebar
4-6 mm
Throttle lever free play
Cable Lock
Adjuster Nut
Adjust as required to obtail 4-6 mm free play
Kit containing cutting attachment shield
mounting bracket and hardware, this
owner's/operator's manual and tool
kit for routine maintenance. Tool kits
vary by model and may include a hex
wrench, and a spark plug/screwdriver
combination wrench.
Strap
Hanger
Handle Positioning Label
Lower cap
Remove air cleaner cover