Troubleshooting - Technoline WS6440 Manual De Instrucciones

Ocultar thumbs Ver también para WS6440:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42

TROUBLESHOOTING

In case your weather station clock shows irrelevant information or digits, it maybe affected by
electrostatic discharge or interferences from other devices. Use a sharp object to press RESET. Your
unit will be reset to default settings and you need to set the time, calendar and alarm time again.
Problem
LCD is blank
No Outdoor Temperature and
Humidity is displayed
Temperature, humidity, or air
pressure is incorrect
CARE OF YOUR WEATHER STATION
1.
Do not expose the unit to extreme temperature, water or direct sunlight.
2.
Avoid contact with any corrosive materials.
3.
Do not subject the unit to excessive force, dust or humidity.
4.
Do not open the inner back case or tamper with any components of this unit.
5.
Do not plug in any other AC/DC adaptor with incorrect specifications or voltage.
SPECIFICATIONS:
Temperature Range
Indoor
+32°F to +122°F (0°C to +50°C) (display shows HH.H / LL.L if out of this range)
Outdoor
-58°F to +158°F (-50°C to +70°C) (display shows HH.H / LL.L if out of this range)
Humidity Range
Indoor
Outdoor
Temperature Resolution
RH% Resolution
Temperature & Humidity
Air Pressure Range
Alarm Duration
Snooze Duration
Solution
1.
Press RESET on the weather station.
2.
Replace fresh batteries in your weather station.
1.
Press and hold
2.
Press and hold
the outdoor transmitter.
3.
Make sure the correct channel is selected on your
weather station (default setting is
4.
Observe if the Low Battery icon appears on the left of the
outdoor temperature. If yes, replace batteries in outdoor
sensor with fresh alkaline batteries.
5.
No other interfering sources are being used (such as
computer monitors, TV sets, headphones, or speakers)
in the path of signal from the outdoor sensor. The signal
travels in a straight line; an electrical source near that
"line" may cause interference.
1.
Press RESET on the weather station.
2.
Make sure your weather station and the outdoor
transmitter are away from sources of heat / cold / direct
sunshine.
20% - 95%
20% - 95%
0.2°F / 0.1°C
1%
measure every 30 seconds
850 hPa to 1050 hPa
2 minutes
5 minutes
EN. 9
/ CHANNEL on the weather station.
/ CHANNEL, then press RESET on
– Channel 1)

Publicidad

Tabla de contenido
loading

Tabla de contenido