Connect The Garage Door Operator To Electrical Power And Controls - Becker BOM 850C-II Manual De Instrucciones

Installation

Connect the garage door operator to electrical power and controls

Warning high voltage:
• Pull out the main plug from the mains socket before you open the cover of the drive head.
• Do not connect any live leads. Only connect potential-free buttons and potential-free relay
outputs.
• After connecting all cables, connect the cover to the drive head again.
Warning:
Before using the operator for the fi rst time, it must be tested to make sure that it is working properly
and safely (see section on Maintenance/Checks).
Warning:
Danger by optical radiation!
If you look at an LED for an extended period from a short distance, this can cause optical glare. Sight
is then severely restricted for a short time. This can result in serious or fatal injuries.
You must not look directly at an LED.
1. External pulse generator
F - Connector for external pulse generator (accessories, e.g. key
switch or code keypad)
2. Input STOP A
36
P
K
I
J
DOWN
H G F E
I H G F E