Included In Delivery - HeiTel CamServer 2c Guía De Instalación Rápida

HeiTel Digital Video GmbH - Quick Installation Guide CamServer 2c
Labelling/
Pin
description
6 12 V +
7 Line out
8 Line in
9 Mic in
⊥
10
11 Speaker +
12 Speaker –
13 12/24 V DC +
⊥
14 12/24 V DC
15 R1 [Common]
16 R1 [normally open]
17 R1 [normally
closed]
18 Al a/d
19 Control in1
20 Control in2
⊥
21
22 Aux in1
23 RS-232 Tx
24 RS-232 Rx

Included in delivery

Component
CamServer 2c basic device
Crossover network cable
USB connection cable
Installation CD including all necessary software packages, software and device
manuals in online format
CamServer 2c Quick installation guide (brief instructions)
CamServer 2c
Type Function
Output, 12 V DC Power supply for a camera, maximum 350 mA load
Audio Audio output, level 0 - 2 V
Audio Card is used
Audio Audio input, level 0 - 2 V
Audio Card is used
Audio Microphone input, electret/capacitor type, supply voltage 1.5 - 4 Volt,
Impedance min. 600 Ohm, sensitivity min. 5 mV/Pa at 1 kHz when the
Audio Card is used
Audio Common ground for the audio signals (Line out, Line in, Mic in) when the
Audio Card is used
Audio Optional loudspeaker connection 1 W/8
Audio
Power, + Nominal voltage 12 - 24 V DC
The permissible supply voltage is 8 to 30 V DC. Ensure that the supply
Power, Ground
voltage remains within the permitted range in all operating modes.
Relay Device configuration allows you to allocate the following functions to any
relay:
Relay
■
Manual remote control with CamControl LITE, CamControl
Relay
CamControl
functions
■
Switching to at least one CamControl receiver unit with active online
connection
■
Error relay
Control input Arm/Disarm input for enabling/disabling dialup to a CamControl receiver
PC, controlled by "Control in" and "Motion Detection"
variants for voltage-monitored control inputs" on page
Control input Camera control inputs for external contact triggered recording and/or
selective dialup to a CamControl receiver unit for video inputs 1 and 2
Control input
(see "Wiring variants for voltage-monitored control inputs" on page
Ground Common ground for all inputs of type "control input"
Control input Tamper input for dialup with automatic switching of video input 1 (V in)
to a CamControl receiver unit
monitored control inputs" on page
Serial TxD RS-232 interface for device reset and for CIO
etc.
Serial RxD
Please ensure that all listed components are included in the package. Please
contact your dealer in case of missing, incorrect, or damaged components.
(nominal ± 0,775 V
pk-pk
(nominal ± 0,775 V
pk-pk
Ohm (if using the Audio
CLIENT distinguishing between switch and pushbutton
(see "Wiring variants for voltage-
21).
Adapter, GPS, serial control,
CamServer 2c
) when the
pk-pk
) when the
pk-pk
Card)
PRO or
(see "Wiring
21).
21).
x
x
x
x
x
19