HeiTel CamServer 2c Guía De Instalación Rápida página 23

HeiTel Digital Video GmbH - Quick Installation Guide CamServer 2c
Driver installation
Establishing the
connection to the
device
Preparing the
receiver PC
Establishing the
connection to the
device
Follow-up
preparation of the
receiver PC
CamServer 2c
USB connection from CamControl LITE to the device
For a USB connection, if required the corresponding driver must be installed
on your receiver PC. The driver can be found in the
program directory, sub-directory \Drivers. If necessary, please consult the
detailed information on driver installation from the
software manual.
Start CamControl LITE. Click on the Dial button and in the
index dialogue window, select the entry USB Direct
a connection to the device using Dial.
Carry out the parameter settings for the device (see "Parameter settings for
the device" on page 24).
TCP/IP Crossover connection from CamControl LITE to the
device
Your HeiTel CamServer
following a device reset using the following IP address: 192.168.31.95
The precondition for communication via a TCP/IP crossover network cable
between the CamServer 2c and the receiver PC with CamControl
that the devices are located in the same IP address group (here:
192.168.31.x).
Check and if necessary change the TCP/IP
settings for the network interface (Start\System
Control\Network
Connection\Properties\Internet
(TCP/IP)), via which your device is connected via
the TCP/IP crosslink cable.
Note down the current settings for the
■
IP-address and Subnet
Change these settings:
■
IP address (e.g.):
■
Subnet mask:
■
Start CamControl LITE. Click on the Dial button. In the Transmitter index
dialogue window, click on the Add button and then select from the next
selection menu Add new
In the dialogue window, enter a transmitter name and the IP address for the
device. IP Address: 192.168.31.95
Confirm the dialogue window with OK.
Select the new entry using the transmitter name. Establish a connection to
the device using Dial.
Carry out the parameter settings for the device (see "Parameter settings for
the device" on page 24).
Once the parameter settings for the device have been made, if necessary
reverse the changes made on the receiver PC for
mask again.
2c can be accessed when in its default status or
Connections\LAN
Protocol
mask.
192.168.31.66
255.255.255.0
transmitter.
CamControl LITE
CamControl LITE
Transmitter
Connection. Establish
LITE is
IP address and Subnet
23