Initial Setup Operation - HeiTel CamServer 2c Guía De Instalación Rápida

HeiTel Digital Video GmbH - Quick Installation Guide CamServer 2c

Initial setup operation

Online help
Port A configuration
Option
Network: Enable TCP/IP
22
Normally closed BS 8418
In the wiring variant
closed BS 8418 with two resistors a
distinction is made between three
different states:
Not triggered: The figure shows
■
the safe state (not triggered) of the detector line or the control input.
Camera alarm: If the "Normally closed" contact is operated, a camera
■
alarm is activated.
Sabotage alarm: If the detector line is interrupted or shorted, a sabotage
■
alarm is activated.
Installation of CamControl LITE
The scope of delivery
CamServer 2c includes the installation CD. Install
commission the device.
To operate the software, the user requires read/write rights on the receiver
PC (administrator rights).
Using an installed Adobe Reader, there is a context-sensitive help available for
CamControl LITE; you can call this up via the F1 key or using the
button.
After starting
CamControl LITE software,
it may be necessary to modify
the settings for Port A. To do
this, select the Setup button
and in the Receiver options
dialogue window the option
Port A. Confirm the changes
made using OK.
Relevant changes:
Description
Enables TCP/IP connection (including USB direct connection and 3G/UMTS) to the
device
Normally
R
L
R
T
R =R
L
(see "Included in delivery" on page
the
Control input
CamServer 2c
Ω
=1.5 k (±1%)
T
19) for your
CamControl LITE to
Help
CamServer 2c