Electric Connections; Technical Data - Beninca BOB21M Manual De Instrucciones Para El Usuario

8) ELECTRIC CONNECTIONS

The cables necessary for the installation of BOB can vary according to the accessories installed.
No connection cable is supplied.
Fig. 7 indicates the cables for standard installation.
List of cables
Connection
A Mains power supply to the control unit
B Motor connection
C Photocell transmitter connection
D Photocell receiver connection
E Key selector connection for external command
F Flashing signal light connection
G Connection of the aerial built-in the flashing light
Legenda
1 Motoreducer
2 Photo-electric cells
3 Key selector (external) or digital keyboard
4 Flash-light
5 Electronic board
The cables used must be suitable for the type of connection. For example, for connection protected by raceways use
H03VV-F cables, for cables in the outdoor environment always use the H07RN-F type.

TECHNICAL DATA

Power supply
Absorbed current
Thrust
Jogging
Protection degree
Operating temperature
Capacitor
Useful stroke:
- with 2 stoppers
- without stoppers
Noise level
Lubrification
Weight
Type
3x1,5mm 2
4x1,5mm (3x0,5mm
2
2x1,0mm
2
4x1,0mm
2
2x1,0mm
2
2x1,5mm
2
RG 58
BOB21M
230Vac 50/60Hz
1,5 A
1800 N
30%
IP44
-20°C / +50°C
9 μF
270 mm
325 mm
<70 dB
Permanent grease
8,2 kg
BOB30ME)
2
BOB30M/BOB30ME
1,8 A
2300 N
12,5 μF
8,6 kg
11