Safety Messages To Installers And Users - Federal Signal 224XST Instrucciones De Instalación Y Mantenimiento

Safety Messages to Installers and Users

It is important to follow all instructions shipped with this product.
This device is to be installed by a trained electrician who is thoroughly
familiar with the National Electrical Code and/or Canadian Electrical
Code and will follow the NEC and/or CEC Guidelines as well as all
local codes.
This device should be considered a part of the warning system and not
the entire warning system.
The selection of the mounting location for the device, its controls and
the routing of the wiring are to be accomplished under the direction
of the facilities engineer and the safety engineer. In addition, listed
below are some other important safety instructions and precautions
you should follow:
• Read and understand all instructions before installing or operating
this equipment.
• Never alter the light in any way. Safety may be compromised if
additional openings or other alterations to the light.
• Do not connect this light to the system when power is on.
• After installation, ensure that the retaining screw and threaded
joints are properly tightened.
• Keep the light tightly closed when in operation.
• After installation, test the lighting system for proper operation.
• After testing is complete, provide a copy of this instruction
manual to all operating personnel.
• Establish a procedure to routinely check the light installation for
integrity and proper operation.
• Not to be used as a visual public mode alarm notification
appliance.
Electraray
Installation and Maintenance Instructions
Models 224XST, 225XST, and 225XST-I
®
5