Complete The Finished Wall; Complete The Installation; Clean-Up After Installation - Kohler K-1681 Guia De Instalacion

Install water- -resistant
wall material so the
paperbound edge is at
least 1/4" (6mm)
above the finished,
concave surface of the
module

4. Complete the Finished Wall

- If you have not already done so, carefully remove the protective tape from the module surfaces.
- Cover the framing with water-resistant wall material so the paperbound edges are within 1/4" (6mm) of the
finished, concave surface of the module. Seal the joints between the module edges and the water-resistant wall
material with silicone sealant.
- Tape and mud the water-resistant wall material. Install the finished wall to the water-resistant wall material. Seal
the joints between the module rim and the finished wall material with silicone sealant.

5. Complete the Installation

- Install any extra grab bars or towel bars to the bridging previously installed. Follow the accessory manufacturer's
instructions.
- Install the shower door according to the manufacturer's instructions.

6. Clean-up After Installation

- When cleaning up after installation, do not use abrasive cleansers as they may scratch and dull the surface. Use
warm water and a liquid, non-abrasive detergent to clean the surface.
- Remove stubborn stains, paint, or tar with turpentine or paint thinner.
- Do not allow cleaners containing petroleum distillates to remain in contact with the module surface for any length
of time.
- Remove plaster by scraping with a wood edge. Do not use metal or wire tools. Use a powder-type detergent on a
damp cloth to provide mild abrasive action to the residual plaster.
B
1022476-2-
Concave Surface
Stud
Furring
Strip
6
Apply a
continuous bead
of silicone sealant
to the nailing- -in
flanges
Kohler Co.