Complete The Finished Wall - Kohler K-1000-H2 Guia De Instalacion

Finished Wall Material
1/2" Cement
Board
Galvanized
Nails or Screws

13. Complete the Finished Wall

CAUTION: Risk of product damage. Use care to avoid scratching the wall jambs.
NOTE: The total finished wall thickness, including furring strips, cement board, and finished wall material
must not exceed 1-1/2" (3.8cm).
Install cement board. Position the cement board so the gap above the top of the footbath rim is no
larger than 1/4" (6mm).
Apply a bead of silicone sealant to the seam between the cement board and the footbath.
Install the finished wall material.
Use a sharp utility knife to carefully remove the protective tape from the wall jambs.
Kohler Co.
1-1/2" (3.8cm) MAX.
Furring Strip
Bead of Silicone
Sealant Between
Cement Board and
Footbath
13
1/4" (6mm)
MAX.
1032108-2-A