Samsung SMT-190D Serie Manual De Usuario página 11

USER'S MANUAL USER'S MANUAL USER'S MANUAL
 Keep personnel away from the installation
location because there is a risk of object falling
during installation.
 Install SOC-N10 in a cool place where there is
no direct sunlight.
 Do not expose SOC-N10 to direct sunlight
during operation or storage.
 SOC-N10 should always be used in a place
where certain temperature and humidity
can be maintained (as specified below).
- Temperature: -10˚C ~ 50˚C(14˚F ~ 122˚F)
- Humidity: Below 90%
3) Installation
1. Make sure the installation location is a place where
it can tolerate 5 times of the total weight of the
camera before installing.
. Connect the cable below the camera after
attaching the provided Mount Bracket to the
desired place.
. Use the handle on the Mount Bracket to adjust the
direction you want to setup for monitoring.
SOC-N10
SOC-N120 Pin Configuration
4) Standard Composition
a. Lens
It has a focal length of .8mm and makes it
possible to observe a relatively wide area.
b. Illumination Sensor
Detects incoming light to control the IR LED.
c. IR LED
This is an infrared LED that is controlled by the
illumination sensor.
d. Camera fitting groove
Enables the camera to be fixed onto the
bracket. You may install it either above or
below the camera if necessary.
e. Speaker
Used to connect the sensor to the camera.
f. SENSOR jack
It outputs the sound signal which was transfered
from alarm sensor.
g. Microphone
Capable of picking up all sound in the vicinity
of the camera location and transmitting to the
monitor.
h. 6-pin modular jack
Used to connect the camera to the monitor or
DVR.
Eng-11
1 SP-
 VIDEO_OUT
 GND
 SP+
5 ALM/AUDIO
6 VDD