5-5) Alarm Setup; 5-6) Event Record Mode - Samsung SMT-190D Serie Manual De Usuario

USER'S MANUAL USER'S MANUAL
5-4) DWELL TIME SETUP
The initial setup status of DWELL TIME SETUP menu is
shown below.
DWELL TIME SETUP
CAM1
CAM
CAM
CAM
CAM5
CAM6
CAM7
CAM8
QUAD-A
QUAD-B
1. DWELL TIME SETUP
- Pressing SEQUENCE button in Single Screen will
bring up the SEQUENCE MODE. You may set the
time display for each channel. If you set zero (0)
seconds as the DWELL TIME for a particular
channel, the set channel will be skipped and next
channel will be shown. You may set time in the
QUAD-A, QUAD-B screens.
[0SEC, 1SEC, SEC, SEC.................... ~ 60SEC]
- Use , , , ,

5-5) ALARM SETUP

• Function: Allow users to set the ALARM MODE for
each camera.
• Setting method: Move to ALARM SETUP MENU by
using /KEY in the SETUP MENU, and press the
ENTER SWITCH to display the OSD as shown in the
figure below. (The figure shows the initial setting status.)
ALARM SETTING
CAMERA1
CAMERA
CAMERA
CAMERA
CAMERA5
CAMERA6
CAMERA7
CAMERA8
HOLD TIME
ALARM ON TIME
ALARM OFF TIME
ALARM TONE
(1) CAM1 to CAM8 item sets whether the alarm sensor
connected to the camera is used or not.
(ON: Alarm function setting, OFF: Alarm function
canceling)
() HOLD TIME item sets time to freeze alarm operation
when alarm occurs.
(HOLD TIME to be set: 05SEC ~ 1MIN ~ 0MIN)
07/07/07 1:0:01
0 SEC
0 SEC
0 SEC
0 SEC
0 SEC
0 SEC
0 SEC
0 SEC
0 SEC
0 SEC
key to make changes.
07/07/07 00:00:01
ON
ON
ON
ON
ON
ON
ON
ON
05SEC
00:00
00:00
ON
Note
If you want to carry out the alarm operation, you must
preset ALARM ON/OFF TIME in monitor before
CAMERA ALARM is set to ON.
() ALARM TONE sets whether or not alarm tone
(high-pitched tone)sounds when an ALARM occurs.
(ON: ALARM TONE operation, OFF: Cancel)

5-6) EVENT RECORD MODE

The initial setup status of EVEVT RECORD SETUP
menu is shown below.
1. EVENT RECORD ENABLE
If you want to start recording when Alarm goes off,
then select ON. If you do not want to start recording
when Alarm goes off, then select OFF. If you set
EVENT RECORD ENABLE to ON and exit the menu,
system starts recording whenever Alarm is activated.
The following screen shows that ALARM recording is
in progress when ALARM is activated.
It shows the ALARM for Channel  is activated with a
"A" mark. [ON/OFF]
Eng-1
07/07/07 00:00:01
EVENT RECORD SEUTP
EVENT RECORD ENABLE OFF
PRE ALARM TIME LIMIT 0 SEC
POST ALARM TIME LIMIT 1 MIN
MOTION DETECTION OFF
SENSITIVITY NORMAL
MOTION CH SETUP...
07/01/05 00:00:01
CAM1 CAM CAM
A CAM CAM5 CAM6
CAM7 CAM8