Operating Mode - Samoa 366 000 Guía De Servicio Técnico Y Recambio

Contador electrónico
Ocultar thumbs Ver también para 366 000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT: Always read the instructions prior to using for the first time.
HANDLING
1 ON/RESET
Press once only to switch on the meter.
Keep pressed to reset the partial meter or the "Trip"
to zero.
On/Off
• The meter is probably switched off when you wish
to use it.
• Press the ON/RESET button to switch it on (fig. 1). The
meter performs a check on the display by showing
all the segments briefly (fig. 2) and then on the dis-
play shows a similar status to that shown (fig. 3).
Fig. 1
Fig. 2
• The display shows the partial meter.
• Although switched off, the meter automatically goes
to an On status when detecting fluid flow and starts
to record the quantity released by showing the
partial meter.
• In order to save energy the meter switches off
automatically after 30 seconds of inactivity. The
registered data are stored.
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com

Operating mode

2 SELECT
Consecutively press to browse the various functions:
Fluid release
• To release fluid, switch on the meter by pressing the
ON/RESET button or simply start to release and the
meter will automatically switch on by starting to
register the fluid.
• If, after successive measurements, (fig. 4) you wish to
set (fig. 6) the partial meter to zero, hold down the
ON/RESET button for a while (fig. 5).
Fig. 3
Fig. 4
• Each unit of volume released increases both the
partial meter and the total meter.
• When the meter switches off, or the batteries are
removed, the data of the last measurement taken
are stored.
Fig. 5
Fig. 6
R. 09/14 836 826
3

Publicidad

Tabla de contenido
loading

Tabla de contenido