EN
INTRODUCTION
WARNING: This unit is intended for profesional
!
use. Read all the instructions in this manual prior
to use.
• The 366855 and 366856 meters are an oval gear with
mechanical registrator models.
• Only use the unit for the purposes for which is intented.
• This device has not been approved to be used in
commercial transactions.
• Do not alter or modify the unit.
INSTALLATION
The meter can be connected to a control gun or installed
directly in the distribution line pipe. It's recommendable
to install a cut-off valve before the meter to facilitate its
maintenance or repair.
The meter has a ½" BSP connection at the inlet and
outlet. It also includes an inlet flange and a flange at the
outlet with seating for an O-ring seal, which enables
OPERATING MODE
IMPORTANT: Always read the instructions prior to using for the first time.
*Depending on the version the units displayed are gallons-quarts or litres-litres.
2
836 897 R. 04/21
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
• Do not exceed the maximum unit working pressure. See
page 4, technical specifications.
• Use the unit with fluids and solutions which are compatible
with the moist parts of the unit. See the relevant section
of the technical specifications.
• Observe the manufacturer's safety warnings for the fluids
used.
• The 366855 model shows litres in the total recorder and
litres in the resettable partial recorder.
• The 366856 model shows gallons in the total recorder
and quarts in the resettable partial recorder.
connection for the range of guns and original Samoa
accessories.
The solid particles entrance in the measuring chamber
may lead to malfunction, so it's highly recommended to
install a filter before the meter (400 microns).
1
Total recorder*
2
Resettable partial recorder*
3
Reset button