Installing Handle; Removing Handle - RIDGID RV2400A Manual Del Usuario

SP6636 1/10/07 9:52 AM
Drum/Caddy Assembly (cont.)
8. Insert the caster stem into the socket
of the caster foot as shown. (Front
casters only).
9. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will be able to hear the
ball snap into the socket and the
caster will swivel
positioning is correct.
10. Install (4) #10 x 1-3/4" screws into
matching holes on both right and left
side of caddy, securing the caddies to
the bottom of the drum. Tighten
screws until just snug. Do not over
tighten the screws, as this may deform
the caddies.

Installing Handle

Press and hold release buttons while
installing handle into handle receptacles in
drum (See illustration).
NOTE: An audible snap of release buttons
indicates successful engagement of
handle.

Removing Handle

Press and hold release buttons as shown.
While firmly pushing in release buttons,
pull handle upwards to remove (see
illustration).
Page 10
Caster (2)
easily when
10
Caster Stem
Caster Ball
Socket
#10 x 1-3/4"
Screw (4)