Removing/Installing/Storing The Metal Handle; Lowering Handle For Storage - RIDGID WD7000 Manual Del Operador

Removing/Installing/Storing
The Metal Handle
Your metal handle comes packaged in
the dust drum. You must remove the
metal handle from the dust drum and
install the handle in the correct direction,
bent area facing away from the back of
the Vac, before continuing. (Also remove
the 8" wheel and set aside for
installation).
Installing Handle
Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.

Lowering Handle for Storage

To store Wet/Dry Vac, press and hold
release buttons while firmly sliding handle
down.
Removing Handle
Press and hold release buttons, as
shown. While firmly pushing in release
buttons, pull handle upwards to remove.
SM AR
Handle
Receptacle (2)
6
TC AR T
Latch (2)
Pull Down and
Slide Dust Drum
Out of Wet/Dry
Vac Unit
Handle
Press and
Hold Release
Buttons
Release
Button (2)