Klippan TRIOFIX Manual De Instrucciones página 16

Klippan Triofix Instruction manual
Rear faced with ISOFIX attachment
9-18kg D
If you find it difficult to get at the ISOFIX mounts, use the
ISOFIX guides.
Fold down the support leg; make sure the indicator for
locking is all green.
Press the ISOFIX adjustment button, at the same time
push outwards the ISOFIX lockers.
Press the ISOFIX lockers against the car's ISOFIX fasteners
until you hear a click when the latch gets locked.
Make sure that the indicator is green on both sides. This
ensures that the base is properly locked.
Push the base onto the car seats backrest, the black
frame must be tight to the backrest.
Adjust the height of the supporting leg by pulling out the
red button.
Adjustment of internal belt height
Pull out the internal belt to their full extent according to
point 12.
Release the shoulder belt pipe from the back of the seat,
move the pipe to the new height and replace the pipe,
push one end of the pipe into the mount and then press
the other end of pipe into the other mount.
The strings should be at the same level as the lower part
of the head support.
Adjustment of headrest height
Pull the handle and adjust the height.
(1-19)
1
2
3
4
5
6
7
8
9
10
Install the TRIOFIX seat to the base so the foremost
fastening pipe of the seat fits into the fastening point
farther behind on the base. At the same time pull the
seat forward at which time the larger locking-indicator
becomes green. When the red indicator is no longer
shown the seat is properly attached to the base.
Position the child into the seat
Lift the button (A) in order to pull the shoulder belts (B)
as far out as possible.
Open the belts by pressing the red push-button (C) and
put the belts aside (D). Fold forward the crotch strap with
the buckle and its padding (E).
Place the child in the seat with the crotch strap between
the child's legs (F).
Put the straps' locking clasps together (G), and then click
them into the buckle (H).
Tension the child seat's belt by pulling the strap (I).
Detaching the seat
Detach the TRIOFIX seat from the base by pressing both
of the opening clasps on the seat as you lift the seat from
its backrest.
Rear faced with the cars 3P belt
9 -18 kg (2, 7-19, 20-23)
Open the lock for the car's seatbelt.
Thread the car's lap belt under the blue mounts, re-lock
the safety-belt.
Tension the safety-belt properly. Then thread the car's
shoulder belt through the mounts.
Lock the belt locking device.
Note pictures 7-19
16
11
Fitting the seat
12
13-14
15
16-17
18
19
Note picture 2.
20
21
22
23