Auto Code Search - One for All OARN03S Guia Del Usuario

Ocultar thumbs Ver también para OARN03S:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Auto Code Search

The Auto Code Search goes automatically through all the codes
for the device you're trying to control. When you find the one
that operates your device, you can stop the search and store
that code.
TIPS: Each device key is associated with a type of device—the
TV is preset to search for TVs, SAT•CBL•DTC for satellite
receivers, cable boxes or digital TV converters, and DVD•VCR
for DVD players. To program the DVD•VCR key to control a PVR
or VCR, see the Reassigning the DVD•VCR Key to Control a VCR
section.
To exit without saving a new code at any point in the Auto
Code Search, press the EXIT key.
1.
Manually turn on the device you want to control.
2.
Press and hold the device key you want to program. The
POWER key illuminates.
While you're holding down the device key, use your other
hand to press and hold the remote's POWER key at the
same time. The POWER key turns off.
3.
Wait until the POWER key comes on and stays on. Then
release both keys.
4.
Point the remote directly at the front panel of the device
you want to control. Press PLAY on the remote and wait 5
seconds. The remote is testing a batch of 10 codes on your
device.
Did your device turn off?
YES: Go to step 5.
NO: Press PLAY again. The remote tests the next batch of
10 codes.
Keep pressing PLAY every 5 seconds until your device turns
off.
5.
When your device turns off, press the REVERSE key on the
remote and wait at least 2 seconds. The remote tries the
last of the previous ten codes.
Did your device turn on?
YES: Press the STOP key. You're done! You've programmed
this device key.
NO: Press REVERSE again. The remote tests the next code in
the batch.
Keep pressing REVERSE every 2 seconds until your device
turns back on. When it does, press STOP.
Note: If you accidentally press the REVERSE key after your
device turns on, press the FORWARD key. Then, wait two
seconds to see if your device turns off again.
NOTES
Throughout the programming of each key, be sure to keep the
remote pointed at the IR sensor of the device you are currently
programming the remote to control.
Test the remote with the device to make sure the device key is
programmed with the correct code for maximum functionality.
If some features don't work, try a different code. See the
"Testing the Code for Maximum Functionality" section on the
next page for more information.
continues on next page...
3

Publicidad

Tabla de contenido
loading

Tabla de contenido