Search Method - One for All UCR-7555 Manual Del Usuario

Setting up the ONE FOR ALL 5
--> If your device does not respond to the ONE FOR ALL 5 after you
have tried all the codes listed for your brand.
--> If your brand is not listed at all.
The Search Method allows you to scan through all the codes contained
in the memory of the ONE FOR ALL 5.
Example: To search for your TV code:
1 Switch your television on (not on standby) and aim your ONE FOR ALL
at your TV.
2
3
4
5
6
7
- Most TV's do not switch on pressing the POWER key. Please try pressing a
"number" key or the "TV-text off" key to switch your TV back on.
- If you cannot control your Television properly, please continue the Search
Method, you may be using the wrong Code.
- To search for the code for another device follow the instructions above only
press the appropriate device key instead of TV during step 2.
- If the original remote control of your Video recorder or DVD player does not
have a POWER key, press PLAY instead of POWER during step 5.
WWW.ONEFORALL.COM

Search Method

Press the TV key on your ONE FOR ALL 5.
Press and hold down MAGIC until the ONE FOR ALL 5's
TV key blinks twice (the red LED underneath the TV key
will blink once and then twice).
Press 9 9 1. The TV key will blink twice.
Next, press POWER.
Aim the ONE FOR ALL 5 at your Television. Now press CH+ over
and over, until your Television turns off (every time you press
the CH+ key the ONE FOR ALL 5 will send out a POWER signal
from the next code contained in the memory). You may have
to press this key many times (up to 150 times) so please
be patient. If you skip past a code, you can go to the previous
code(s) by pressing the CH- key. Remember to keep pointing
the ONE FOR ALL 5 at your Television while pressing this key.
As soon as your television turns off, press MAGIC to store the
code.
7