General Features; Technical Characteristics; Electrical System Set Up; Preliminary Checks - Vimar Elvox ESM1 Manual Para El Conexionado Y El Uso

ACTO

General features

Automatic gate system, ACTO 400D, for residential sliding gates. The non-reversible, electromechanical actuator is equipped with a low-voltage 12 V DC
motor and a mechanical release which enables the gate to be opened and closed manually. The motor operates a gear unit, lubricated with permanent grease,
which is enclosed in a thick but extremely compact die-cast aluminium housing. The electronic control board is integrated in the body of the actuator, with the
provision of a housing for the back-up battery (optional).

Technical characteristics

Supply voltage
Frequency
Board voltage supply
Motor voltage supply
Frequency of use
Rated motor power
Motor speed
Rack
Operating temperature
Protection rating
Maximum gate weight
Dimensions (WxHxD)
Electrical system set-up (standard system)
5
Key
1- Photocells
2- Selector switch
3- Flashing light
4- Gear motor
5- Rack

Preliminary checks

For the automatic gate system to function properly, the structure of the existing gate, or the one to be made, must meet the following requirements:
- The wheels of the gate are mounted in such a position as to provide stability to the gate and are in a good condition and efficient.
- The rail is clear, straight and clean throughout its length with mandatory stops for both opening and closing.
- The top guide is aligned with the rail, the sliding blocks are intact and lubricated and with a clearance of approximately 1 mm. on each side so as to facilitate
the sliding of the gate leaf.
- The spaces between the moving and fixed parts of the gate are of the size required by the national standards or in any case comply with safety standards
by applying an adequate protection system
- The weight of the gate must not exceed 400 kg
- No mechanical closing locks
It is recommended to take the necessary steps to ensure the reliability and safety of the automatic gate system.
12
1
4
230 V~
230 V~
120 V~
ESM1 230 V ac (+10%, -10%)
ESM1.120 120 V ac (+10%, -10%)
50-60Hz
14 Vac
12 Vdc
Residential service
50 W
1300 RPM
Module 4
From -25°C to +55°C
IP45
400 kg
308x270x225 mm
3
2
1
EN