Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ACTO
USER GUIDE
USER INFORMATION
-
Carefully read all enclosed instructions and documentation.
-
This product must be used exclusively as specified in design, any other use is to be considered improper and therefore hazardous.
-
The information in this document and any attached paperwork may be subject to modification without notice. It is supplied as a guideline for product
application.
-
In the event of a fault and/or poor operation of the automatic gate system, disconnect the installation from the mains by means of the main switch and
contact professionally qualified personnel or an authorised service centre for assistance. Never attempt direct repairs or intervention.
-
Have the general operation of the automatic gate system and the safety devices checked once a year by qualified personnel.
-
In the event of mains power failure, the back-up battery ensures the operation of the automatic gate system for a limited period. Should the battery be
flat or missing, manually unlock the motor, open the door, using the customized key, and turn the unlocking lever approximately 5 and a half times. It is
advisable to move the gate into the fully open position (opening limit switch engaged) and reset unlocking by turning 5 and a half times, which is to prevent
any undesired movement of the gate (with the gear motor unlocked the gate is free to move, which may cause damage to property persons or persons).
Once the power supply is restored, the electronic board will charge the back-up battery and the gate will return to normal operation after a command pulse.
CAUTION: Unlock and reset with the gate stationary.
MANUAL RELEASE
-
To unlock, insert the key, at point A, and turn it 180° anticlockwise.
-
Open the door B and rotate the knob C 5 turns clockwise
-
The actuator is unlocked. Close the door B.
Location of the buttons for controlling the gate (selectors, keypads, buttons, etc.)
Control device
Association of the remote control buttons
Button
Not used
Button 1
Button 2
If the automatic closing function is active (when the gate is stationary and open the flashing light stays
on) the gate closes after the set time. You can disable this function by pressing the button on the remote
control before the gate reaches the fully open position. If the sequential function is active it opens-stops-
closes.
If the gate meets an obstacle on closing, and automatic closing is active, the control unit makes 5 attempts
at closing, after which it remains open. In this case it is necessary to remove the obstacle from its path and
control the gate with the transmitter and button.
System Maintenance
Every 2 years it is recommended to replace the batteries in the remote control. Once a year check the rail
is clean and the gate slides properly.
18
A
Location
Controls total opening of the gate
Controls partial opening of the gate
C
Controls the second channel output
Button 1
Button 2
B
EN
Publicidad
Capítulos
Tabla de contenido
