Selection Of The Connecting Material; Technical Data; Preparations At The Workplace; Fitting / Removing The Hilti Retaining Strap (Not Supplied With The Tool) - Hilti NCR 060 II-A22 Manual De Instrucciones Original

3.5 Selection of the connecting material

A table to assist with selecting the type of cable and cable terminal to be used can be found at the end of
these operating instructions.

4 Technical data

Rated voltage
Weight
Max. crimping force
Crimping time
5 Operation

5.1 Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Remove the battery before making any adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.2 Inserting the battery
CAUTION
Risk of injury! A falling battery presents a risk of injury.
▶ Take care to ensure that the battery is inserted correctly.
1. Push the battery into the battery holder until it engages with an audible click.
2. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release buttons.
2. Pull the battery out toward the rear.

5.4 Fitting / removing the Hilti retaining strap (not supplied with the tool)

CAUTION
Damage to the tool and/or the retaining leash. Incorrect handling may lead to damage to the tool
and/or retaining leash.
▶ Do not use a metal chain as a retaining leash. Do not use a retaining leash with a length of more
than 6 ft (2 m). Failure to observe this point may lead to damage to the tool and/or the retaining
leash in the event of the tool falling.
Note
To help avoid the risk of injury due to a tool falling when working at a height, we recommend use of
the Hilti retaining strap. The retaining strap allows a securing cord or leash to be attached. National
regulations applicable to working in high positions must be observed when working with the tool.
1. Fitting the strap => Remove the battery. Insert the two tabs on the retaining strap into the slots on each
side of the base of the tool. Secure the retaining strap with the screws supplied. Refit the battery.
Printed: 27.07.2017 | Doc-Nr: PUB / 5365804 / 000 / 00
2
3
NCR 060 II-A22
21.6 V
2.98 kg
(6.57 lb)
53 kN
(11,900 lb )
f
≈ 5 s
4
English 5