Fitting The Tandem Seat Units; Removing The Tandem Seat Units; Fitting The Tandem Carrycots; Removing The Tandem Carrycots - Kiddy Evostar 1 Manual De Instrucciones

EN

7.3 Fitting the tandem seat units

Fit the tandem adapters as described in point 7.1. Fit the lower seat
unit adapter cups ( g. 36) on to the seat legs (left and right). With
the chassis handle fully extended, lower the seat unit into the tandem
adapters until it locks into place with a click ( g. 37).
Note: e adapter cups are only for use with the tandem seat in the
lower position.
Note: Always t the lower seat rst in the forward facing position. e
lower seat unit has a 2 position recline only. Do not try force the seat
into the 3rd recline position. Always t the upper seat unit in the for-
ward facing position.

7.4 Removing the tandem seat units

Depress the grey buttons on the side of the seat unit ( g. 38, no. 1)
and lift the seat upwards from the chassis ( g. 38, no. 2). Remove the
adapter cups.

7.5 Fitting the tandem carrycots

Fit the tandem adapters as described in point 7.1. Holding the lower
carrycot by the carry handle, guide the carrycot in horizontally foot-
end rst until the ttings on the carrycot line up with the ttings on
the tandem adapter. Push the carrycot into the tandem adapter until
it locks into place with a click. Fit the upper carrycot into the upper
position by lowering it into the tandem adapter until it too locks into
position with a click ( g. 39).
Note: Always t the lower carrycot rst in the forward facing position.
Always t the upper carrycot in the parent facing position.
e carrycot hood has an intermediate position (45 degrees) to allow
viewing when the carrycot is used in the tandem mode, lower position.

7.6 Removing the tandem carrycots

Depress the buttons on the side of the carrycots ( g. 40, no.1) and lift
upwards from the chassis ( g. 40, no. 2).
17