Nice NiceOne OXI/A Serie Instrucciones Y Advertencias Para La Instalación Y El Uso página 12

15 – MANAGING RELEASE OF THE
EN
TRANSMITTER KEYS
(Function available only on transmitters using encoding
O-Code/A)
[with O-Box / O-View] – Normally, after sending a com-
mand, on release of the key the manoeuvre is not stopped
immediately but proceeds for a very short pre-set interval.
If necessary, the manoeuvre can be interrupted at the exact
time of key release (required for example during minimal
adjustments) by enabling this function (factory setting OFF).
16 – ENABLING (or disabling)
COMMAND DELIVERY ON THE
"T4 BUS" NETWORK
[with O- View] – On systems in which connection is via the
"T4 Bus", if more than one receiver is installed, and there is
the need for control at a distance greater than that normally
covered by the transmitter and receiver, this function can
be enabled (on at least 2 receivers) to increase the receiver
reception range.
This enables the receiver that receives a command "via
radio" to re-transmit the command via the Bus cable to the
final receiver (in which the sending transmitter identity code is
memorised), so that this can execute the command.
To enable or disable the option to receiver and/or send radio
codes on the "T4 Bus" in a receiver (factory setting OFF), the
receivers concerned must be duly programmed, using the
O-View programming unit.
10
17 – CREATING THE "FAMILY GROUPS"
OF TRANSMITTERS
[with O-Box] – Each code memorised on the receiver can
be associated with one or more "family groups", from the 4
available.
The formation of groups and their activation or deactivation
(factory setting OFF) is managed by means of the O-Box pro-
gramming unit while use of the groups, for example in a set
time-band, is managed by means of the O-View programming
unit.
18 – PROTECTION OF PROGRAMMED
FUNCTION SETTINGS
[with O-Box / O-View] – This function enables the user to
protect all programmed functions on the receiver, also disa-
bling functionality of the key and relative led. The function is
enabled by entering a password on the receiver, i.e. a maxi-
mum of 10 digits, as set by the installer.
When the function is enabled, before programming and
maintenance of the receiver, the special password must be
entered on the programming unit to unlock the receiver.