Nice NiceOne OXI/A Serie Instrucciones Y Advertencias Para La Instalación Y El Uso página 7

"enable code" (the first twenty times only). The receiver, after
recognising the "enable code" of an OLD transmitter (previ-
ously memorised on the receiver) automatically memorises the
identity code of the NEW transmitter sent to it.
• Preventing accidental use of this memorisation proce-
dure
To prevent memorisation on the receiver of other transmitters
not compatible with the system but with the "enable code" of
a transmitter already memorised on the receiver, this proce-
dure can be "locked" (or unlocked) by programming the func-
tion in paragraph 10.
As an alternative to locking memorisation of the entire receiver,
transfer of the "enable code" can be disabled exclusively for
some or all OLD transmitters already memorised. This opera-
tion can be performed using the O-Box programming unit.
3
7 – MEMORISATION OF A TRANSMITTER
USING THE PROCEDURE IN THE
VICINITY OF THE RECEIVER
[with a transmitter already memorised]
A NEW transmitter can be memorised in the receiver memory
without acting directly on the key of the receiver, but by sim-
ply working within its reception range. To use this procedure,
an OLD transmitter, previously memorised (in "Mode I" or in
"Mode II") and operative, is required. The procedure enables
the NEW transmitter to receive the settings of the OLD version.
WARNINGS:
• Use only one of the two procedures described below,
according to requirements.
• The procedure must be performed within the recep-
tion range of the receiver (maximum 10-20 m from
receiver).
• Repeat the same procedure for each transmitter to be
memorised.
Standard Procedure (valid for all Nice receivers)
01. On the NEW transmitter, press and hold the key.... for at
least 5 seconds (see note 1) and then release.
02. On the OLD transmitter, press key.... three times (see
note 1) and then release.
03. On the NEW transmitter, press the same key pressed in
point 01 once and then release.
Alternative Procedure (valid for this receiver only)
01. On the NEW transmitter, press and hold the key.... for at
least 3 seconds (see note 1) and then release.
02. On the OLD transmitter, press and hold the key.... for at
EN
5