Troubleshooting; Accessories; Notes On Disposal - BE QUIET! SFX POWER 2 Serie Manual Del Usuario

Fitting your new be quiet! SFX Power 2 / TFX Power 2 power supply:
∙ Place the new power supply in the space provided in the PC case and connect to the rear panel using
the four screws provided. Do not use excessive force.
∙ Plug the 20/24 pin connector into the socket provided on the motherboard. If you have a 24 pin
connection, place the remaining 4 pins in the correct position before you plug the connector into
the socket. If you have a motherboard with a 20 pin connector, fold the additional 4 pins to one side.
∙ Now plug the 12V-P4 connector for the CPU into the socket provided on the motherboard.
6.

TROUBLESHOOTING

Please note:
If you have an ATX motherboard, the power supply is enabled by the motherboard in order to boot the
PC. For this reason, please refer to the motherboard or case manual to check whether the on/off switch
is connected correctly�
Caution: There is a risk of fatal injury when working on power sources. If you notice traces of smoke,
damaged cables and exposure to liquids, immediately disconnect the power from the mains and do not
use it again.
Never open the power supply case. High-voltage components in the interior of the power supply may still
be live after a longer period of disuse.
Please have any and all necessary repairs conducted by an authorized expert!
Opening the device will void your warranty.
If the system in which you installed the power supply does not work properly, check for these possible
sources of error first:
∙ Check that the mains cable to the power supply is correctly and firmly plugged into the power supply
and the socket. Ideally, you should use a separate power socket for the computer power supply.
∙ Check whether all connectors are correctly plugged in, and make any necessary adjustments, such
as in case of incorrect polarity.
∙ Check the connection between the on/off switch on the case to the motherboard. Refer to the
motherboard manual if needed! Switch the power supply on by setting the switch to position "I" (only
for SFX Power 2) and then pressing the on/off switch on the case. If the power supply still does not
switch on, continue with the next item.
∙ Check your system for possible short circuits or faulty hardware, making sure that you switch off the
computer and disconnect all devices not required for the computer to start. Switch the computer
back on. Repeat this process and connect one device after each reboot, until you discover the fault.
If the power supply does not react due to a short circuit, wait for at least 5 minutes before switching
back on as the device is equipped with overload protection.
7.

ACCESSORIES

The power supply package includes the following accessories:
Mains lead, Operating manual, Cable ties, Screws for installing the power supply
8.

NOTES ON DISPOSAL

Due to European directives* you are no longer allowed to dispose of used electrical and
electronic devices as unsorted domestic waste. The devices must be collected separately.
The trash can on wheels pictogram indicates the need to dispose of the device separately.
6