11. Servicing And Care; Burner Cleaning; Cleaning The Ash Pan; Ash Pan Door And Combustion Chamber Door Seals - Bio Bronpi HYDROBOX Instrucciones De Instalación, Uso Y Mantenimiento

Besides the failure codes, the stove can show the following messages that do not block its operation:
MESSAGE
Prob Anomaly on the probes control in check-up.
Service This message means that the operating hours have been reached (1200). It is necessary to call the technical assistance
service.
Block Ignition This message appears when the system has not been turned off manually during the Ignition phase (after the preload): the
system will turn off when it works at full capacity.
Cleaning on Doing a periodic cleaning. Only shown in pellet mode.
Link Error Fail of communication between the card and the display

11. SERVICING AND CARE

The maintenance operations guarantee a proper operation of the product over its lifetime. Not making these maintenance operations will
affect the safety of the product.
11.1.

BURNER CLEANING

In the Hydrobox and Hydrotex models, even though the burner cleaning is automatic, it is necessary to carry out a weekly cleaning.
- Use a vacuum to clean the ashes in the burner.
- Remove the burner from its place and unblock the holes.
- Hoover the ashes which is inside the burner housing.
In the case of model Hydroconfort, as it has an automatic cleaning system, the burner cleaning must be carried out when it is observed that
the holes in the base are obstructed and do not allow the passage of the oxygen for a correct combustion.
11.2.

CLEANING THE ASH PAN

The ash pan should be emptied when necessary. The boiler should not be operated without having
the ash pan in position. In the event of using olive stone as fuel, the amount of ashes will be higher
than those produced by pellet. In this case the ash pan cleaning should be done more frequently.
In the Hydroconfort model there is a capacity viewer, in case you notice that the level is very high, it is
necessary to proceed with the emptying of the ashes.
11.3.

ASH PAN DOOR AND COMBUSTION CHAMBER DOOR SEALS

The seals ensure the boiler air tightness and, thus, a proper performance.
It is necessary to check them regularly; if they are worn-out or damaged they should be replaced immediately.
You can find ceramic cord and self-adhesive fibre at the same Bronpi distributor where you bought your boiler.
These operations should be done exclusively by an authorised technician.
11.4.

CLEANING THE CHIMNEY

When the pellet is burnt slowly, it produces tar deposits and other organic vapours that combined with the
humidity to create soot (creosote). An excessive accumulation of soot may cause problems in the smoke outlet
and the flue may catch fire if not maintained..
The cleaning of the boiler chimney should only be made when the equipment is cold. A chimney sweep should
perform this task and, at the same time, examine the smoke duct (it is recommended to write down the dates
of every cleaning and keep a register of them).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
DESCRIPTION
62 HYDROBOX, HYDROTEX AND HYDROCONFORT