The Control Panel; Turning The Machine On - Hoover NEXTRA HNF6127 Manual De Instrucciones

40002005Eng.qxd 04/10/2004 16:15 Page 17

The Control Panel

CHRONOVISION
Door Locked Indicator Temperature
Programme
Display
Selector
Selector
Spin Speed
Pre Wash Fast Iron
Start/Pause Start Delay Extra Rinse
Selector
The programme selector must be returned to the OFF
position to reset the controls between each wash cycle.

Turning the machine on

The machine is turned on by selecting a programme via the programme
selector. This status will be indicated by the STOP indicator light flashing, this
light will continue to flash until the machine has started or the machine is
returned to the OFF position.
Start/Pause ( )
Start
After selecting the programme and the required options press the button
once to start the machine. The STOP light will stop flashing and START light
will illuminate and there will be a short time delay to the start of the
programme while the machine sets the wash parameters for the selected
programme and options. If the duration of the programme you have selected
is shorter than 60 minutes, then the time remaining indicator will illuminate
accordingly. The indicator light will also illuminate a few seconds after
pressing the button.
17