Parts And Maintenance - Ingersoll Rand 317A Especificaciones Del Producto

EN
Aluminum oxide, resin bond abrasive paper is recommended. Paper can have 7/8" diameter
center hole, or pressure sensitive adhesive.
Select Proper sandpaper and pad for application. Use either resin-backed or pressure-sensitive
sandpaper.
For Resin-backed Paper:
1. Insert Pad Nut (15) through sandpaper and Backing Pads (16).
2. Always use both Backing Pads (discs), with 3" pad positioned closest to sander. Make sure the
pad's label faces the Sander. See illustration (Dwg. TP PF150).
3. Thread Pad Nut (15) into Flange (14) of Sander.
4. Hold sanding adapter with the Insert Holding Tool (17). Turn backing pad and sandpaper
until Pad Nut (15) is tight against Flange (14).
5. Remove Insert Holding Tool (17).
(Dwg. TP PF 150)
For Pressure Sensitive Paper:
1. Insert Pad Nut (15) through Backing Pads (16).
2. Always use both Backing Pads (discs), with 3" pad positioned closest to sander. Make sure the
pad's label faces the Sander. See illustration (Dwg. TP PF150).
3. Thread Pad Nut (15) into Flange (14) of Sander.
4. Hold Sanding Adapter with the Insert Holding Tool (17). Turn the Backing Pad and sandpaper
until Pad Nut (15) is tight against Flange (14).
5. Remove backing. Press paper firmly against backing Pad. Paper should be centered into pad,
over hanging no edge of the pad by more than ¼".

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
Backing Pad 5"
Pad Nut
Faces Sander
Insert Holding Tool
Backing
Pad 3"
04580395_ed4