Product Safety Information; Product Specifications; Installation And Lubrication; Parts And Maintenance - Ingersoll Rand CA Serie Especificaciones Del Producto

Product Safety Information

Intended Use:
These Air Belt Sanders are designed for light sanding such as smoothing edges and welds.
For additional information refer to Product Safety Information Manual Form 04584942.
Manuals can be downloaded from www.irtools.com.

Product Specifications

Model(s)
CA120RS812
CA120RS418
CA120RS818
CA200RS812
CA200RS418
CA200RS818

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from
valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse
upstream of hose and use an anti-whip device across any hose coupling without internal shut-off, to prevent
hose whipping if a hose fails or coupling disconnects. See drawing 16577249 and table on page 2.
Maintenance frequency is shown in circular arrow and defined as h=hours, d=days, and m=months. Items
identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts
be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll-Rand Office or Distributor.
80154719_ed1
Belt Size
inch (mm)
12 x 1/2 (305 x 13)
18 x 1/4 (457 x 6)
18 x 1/2 (457 x 13)
12 x 1/2 (305 x 13)
18 x 1/4 (457 x 6)
18 x 1/2 (457 x 13)
6. Thread size
7. Coupling
8. Safety Air Fuse
9 Oil
10. Grease
Arbor Speed Belt Speed
rpm sfpm
12,000 2,700
12,000 2,700
12,000 2,700
20,000 4,500
20,000 4,500
20,000 4,500
EN
EN-1