Parts And Maintenance - Ingersoll Rand 317A Especificaciones Del Producto

(Dwg. TP PF150)
For pressure sensitive paper:
1. Insert Pad Nut (15) through Backing Pads (16).
2. Always use both Backing Pads (discs), with 3" pad positioned closest to sander. Make sure the pad's
label faces the Sander. See illustration (Dwg. TP PF150).
3. Thread Pad Nut (15) into Flange (14) of Sander.
4. Hold Sanding Adapter with the Insert Holding Tool (17). Turn the Backing Pad and sandpaper until Pad
Nut (15) is tight against Flange (14).
5. Remove backing. Press paper firmly against backing Pad. Paper should be centered into pad, over
hanging no edge of the pad by more than ¼".

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts
be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll-Rand Office or Distributor.
4
5" Backing
Pad
Pad Nut
Faces Sander
Insert Holding Tool here
HIGH
SPEED
3" Backing LOW
SPEED
Pad
Form 04580395-Edition 2