Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Product Safety Information
Intended Use:
This Sander is designed for light sanding, feather edging and rust removal.
For additional information refer to Product Safety Information Manual Form 04580387.
Manuals can be downloaded from ingersollrandproducts.com
Product Specifications
Free Speed
Model
rpm
317A
18000
† K
= 3dB measurement uncertainty
pA
‡ K
= 3dB measurement uncertainty
wA
*K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16578577 and table on page 2. Maintenance frequency is shown in
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
Sandpaper Installation
Always turn off the air supply, bleed the air pressure and disconnect the air supply hose
•
when not in use, before installing, removing or adjusting any accessory on this tool, or
before performing any maintenance on this tool or any accessory.
Backing Pads (16) should be inspected for signs of irregularities such as fractures,
•
excessive wear, nicks, cuts, at the edges of center hole. Pads showing such
characteristics should not be used.
04580395_ed4
Pad
Sound Level dB (A)
Diameter
inch
mm
† Pressure (L
5
127
WARNING
WARNING
(ISO15744)
) ‡ Power (L
P
86.7
99.7
6.
Thread size
7.
Coupling
8.
Safety Air Fuse
9.
Oil
Vibration
(ISO28927) m/s
)
Level
W
3.3
0.8
EN
2
*K
EN-1
Publicidad
Tabla de contenido
