Kohler K-1737-K1 Guía De Instalación Y Cuidado página 10

10" (254 mm) Silver
or 16" (406 mm) White
Crossover Cable
Control Cable
Input (Location
Varies By Model)
Steam
Adapter
25' (7.6 m)
Data Cable
5. Install the Adapter – Single Steam Head
Remove the adhesive backing from the steam adapter.
Mount the adapter firmly to the side of the steam generator.
NOTICE: Do not pinch, nail, wedge, or use undue force when
handling the silver crossover cable. Any damage may result in
adapter failure. If the adapter is not installed immediately, protect
the cable ends with tape or other shielding material.
Connect the 10" (254 mm) silver or 16" (406 mm) white crossover
cable to the steam adapter and the steam generator.
Connect the temperature sensor wire to the corresponding port
on the steam adapter.
Connect the data cable to the steam adapter and route the cable
to the controller installation location.
Install the terminator into the "Optional" port on the steam
adapter.
1235393-2-C
Temperature
Sensor
Steam
Head
Controller
10
Interface
Kohler Co.