Setting The Clock; Using The Snooze Function - Bigben RR90 EPOK Instrucciones De Funcionamiento

Setting the Clock

• In standby mode, press & hold Clock Set [10] for 2 seconds. The display will flash.
• Press Hour Set / Minute Set (11, 12) to set the hour and minute.
• The clock will display in 24-hour format.
1. Dimmer Control (LED Display)
• Press Dimmer [9] to control the brightness of digits on the display.
• There are 3 levels: High level (brightness)
2. Setting the Alarm
• In standby mode, press & hold Alarm 1 [6] for 2 seconds. The main digits will display 0:00.
• Press Hour [11] & Min [12] to set the alarm hour & minute.
• Press Alarm 1 [6] again to confirm alarm 1 setting.
• Press Skip - /+ [11/12] to switch between the alarm output ringer "bb" (beep sound) and radio ("F")
• Press Alarm 1 [6] to confirm the alarm output (3 selections).
"b1" metal ringing bell; "b2" Buzzer and "FM" radio "
• The product is equipped with a dual alarm. Repeat the above steps to set Alarm 2 [7] & select the
alarm output. Once the alarm is set, the alarm display light will be ON.
Switching Off the Alarm
• To turn off the metal ringing bell, buzzer or FM radio, press any key on rear of alarm (except Snooze).
• The Alarm clock will resume the function at the same time the next day.
Cancelling/Disabling Alarm Function
• In standby mode, Press Alarm [6] or [7] twice. Doing so cancels the alarm function. The alarm
display light will be OFF.
• If no key is pressed for 10 seconds, the system will return to normal mode.

3. Using the Snooze Function

When the alarm is sounding or radio output is on, you may press [9] "SNOOZE". The Snooze display
light will flash. Pressing "SNOOZE" stops the alarm or radio, but the alarm or radio will be re-activated
every 9 minutes. Press Alarm 1 [6] or Alarm 2 [7] or
switches off the Snooze indicator light.
4. NAP Timer
• In standby mode, press [8] to activate the NAP timer. The ringer will sound once the selected time
has elapsed.
• The alarm will start to count down from the default setting of 120 minutes. The user may select other
timer options: 120, 90, 60, 30, 15, 10, 05 & OFF.
• When the ringer sounds, press [8] or
function, press [8] to select OFF.
5. Listen to FM Radio
• Press [5] to switch on the radio mode. The FM indicator light is on & the display shows the current
frequency (e.g. FM92.6 MHz).
• In radio mode, press
for the next station.
Low level (Dim light)
(5) again to switch off the ringing. To cancel the NAP timer
Skip -/+ [11, 12] to adjust the tuning and hold for 2 seconds to search
- EN 5 -
OFF.
(5) to switch off the alarm. Doing so also