Tripp-Lite PDUMH30AT El Manual Del Propietario página 11

Features
F
Units LEDs: The AMPS, KW and VOLT LEDs are used to illustrate the units of
data displayed on the 3-digit display.
Amp LED: When selected, the load is displayed in amps on the 3-digit display.
kW LED: When selected, the load is displayed in kilowatts on the 3-digit display.
Volt LED: When selected, the voltage is displayed on the 3-digit display.
6
Output Circuit Breakers: Two circuit breakers protect equipment connected to
each load bank against overloads. If a breaker trips, the circuit is overloaded and
you need to reduce the load connected to the circuit breaker's load bank. Press
the circuit breaker button to reset and restore power.
7
Ground Connection: Allows you to connect a user-supplied ground wire between
the PDU and any equipment that requires a chassis ground.
8
Cord Retention Bracket (Optional Installation): When installed on the PDU,
cord retention brackets provide secure attachment points for connected
equipment power cords.
9
ENVIROSENSE Port (PDUMH30ATNET, PDUMH30HVATNET &
PDUMH32HVATNET): Use this port to connect a Tripp Lite ENVIROSENSE
environmental sensor to provide remote temperature/humidity monitoring and a
dry contact interface to control and monitor alarm, security and telecom devices.
Visit www.tripplite.com for ordering information. Note: Do not connect a keyboard
or mouse to this port.
10
Configuration Port (PDUMH30ATNET, PDUMH30HVATNET &
PDUMH32HVATNET): Use this port to provide a direct terminal connection to a
computer with a terminal emulation program. A serial cable (part number
73-1025) is included with the PDU. If you need to order a replacement cable,
visit www.tripplite.com
11
Network Interface (PDUMH30ATNET, PDUMH30HVATNET &
PDUMH32HVATNET): Use this RJ-45 jack to connect the PDU to the network
with a standard Ethernet patch cable. The Link LED
several operating conditions, as shown in the table below. This port is not
compatible with PoE (Power Over Ethernet) applications.
Link LED Color
A
Off
Flashing Amber
Flashing Green
15-07-195-93323D.indb 11
continued
Network Operating Conditions
No Network Connection
100 Mbps Network Connection
10 Mbps Network Connection
and Status LED
A
Status LED Color
B
Off Card Not Initialized
Steady Green Card Initialized and Operational
Flashing Amber Error - Card Not Initialized
11
indicate
B
9/2/2015 5:08:18 PM