Tripp-Lite PDUMH30AT El Manual Del Propietario página 13

LED Diagrams
Display Modes
Temperature Display Mode
Number of Sensors Depends on Envirosense Model Used
Humidity Display Mode
Number of Sensors Depends on Envirosense Model Used
Note 1: Press Mode button to go to the next Display mode (vertical movement on this document). Note the Amps, kW, or Volt
sub-Mode will be remembered.
Note 2: Press Enter button to go to the next sub-mode (Amps, kW, Volts) (horizontal movement on this document)
Note 3: The Active Input LEDs will always show the present source powering the load.
Note 4: Press and hold both Mode and Enter buttons for 2 seconds to show the IP address of the connected SNMP card.
Note 5: Press and hold MODE button for 2 seconds to switch to Control modes. (This will go to the FIRST control mode)
15-07-195-93323D.indb 13
(Only Available if Envirosense Connected)
(Only Available if Envirosense Connected)
13
To Previous
Screen
9/2/2015 5:08:19 PM