Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Pressure switch refit
procedure
When the slush led, cold
drink led and led 1 blink on
the electronic board at the
same time,
This indicates that the
pressure switch intervened to
deactivate the compressor.
In order to refit this device, it
is important to follow the
instructions below:
1st. Remove the drip tray.
2nd. Push the black button
as shown in the picture.
In order to avoid this
situation to happen again,
verify the correct position
of the machine as in the
pic.5 pag.43 and/or clean
the condenser as described
at pag.16.
- 21 -
Publicidad
Tabla de contenido
