Stage 2 Base Assembly - Evenflo ExerSaucer Triple Fun Manual De Instrucciones

Stage 1
Stage 1 is used for infants from birth to 4 months old.
C
B
B
Stage 2 is used for infants 4 months old (who can hold up head and neck unassisted)
Stage 2
to walking age and under 30 inches tall.
A
B
B
D
E
D
C
A
1. Place mat on floor.
B
2. Place feet on either side of mat, as shown.
C
3. lnstall toy bar into feet, as shown. Press toy bar down
firmly and rotate until it snaps into place. Pull up on the toy
bar and stalk toys installed into the feet to make sure they
are locked in place.
A
1. Turn base A upside down and locate four stabilizer feet
Insert one side of foot B into the foot bracket hole and twist
the foot until the other side snaps into the opposite hole, as
shown. Repeat until all four stabilizer feet are installed.
To use stabilizer feet:
Flip the four stabilizer feet out from beneath base to prevent
ExerSaucer ® from rocking.
C
2. Locate four pedestals , then turn over and install the
1-1/2 inch (38 mm) spring D with screw
pedestal. Position spring as shown. Do not overtighten
screw.
2
Stage 1
C
F
Stage 2
B .
E in each
C
3. To install a pedestal
the locking tab with the rib
slot with the notch
F
G
H
D
I
J
4. Attach the spring
shown. Once the spring is in place, align all three locking
J
tabs on the pedestal with the slots in the base and snap
the pedestal into place.
J
F
5. Turn the base
locking tabs
through to the underside of the base
over the edge of the openings, as shown.
C
6. Check to ensure that the locking tabs are installed properly
by turning the pedestal
The pedestal MUST spring back into place.
Repeat for all four pedestals.
C
3

Stage 2 Base Assembly

C , hold it above the base F so that
G
lines up directly over the
H .
D I F
to the hook on the base , as
F upside down and make sure the
J on each pedestal C are completely pushed
F and have locked
C
clockwise, then releasing.