Programming Procedure - Cardin DKS Serie Manual De Instalación Y Manual Del Usuario

Attention! Before memorising the transmitters for the first time remember to
cancel the entire memory content.
1. Cancelling the entire memory content
• Press and hold down buttons P1+P2 on
the interface for 5 seconds.
• During the total cancellation procedure
the leds L1 and L2 will remain lit.
• When the procedure has finished buzzer
B1 will sound a lengthy 'beep'.
At this point all codes have been cancelled
2. Setting the master code
The master code allows the keypad /
transponder reader to access the interface
remotely and manage user codes.
• Move jumper J5 on the interface to
'position 2'.

PROGRAMMING PROCEDURE

If you have inserted an invalid master code the
interface will sound 5 consecutive beeps.
25
• Press and hold down the button P1 for
at least 2 seconds.
• During the procedure led L1 will flash
slowly and L2 lights up.
• The buzzer B1 will sound 'beep'.
• The master code memorisation
procedure will be activated with a time
maximum of 30 seconds.
• Type the chosen numerical code into
the keypad to enable access to the
functions (max. 6 digits) and press
*
confirm " "
• The interface will give confirmation by
sounding a 'beep'.