Cardin DKS Serie Manual De Instalación Y Manual Del Usuario página 28

• Within 13 seconds of confirming the
code press one or more functions A-B-
C-D in sequence (e.g. A-C)
*
• Press " " and the interface will give
confirmation by sounding a 'beep'.
The code was accepted and the functions assigned
Transponder
• Move a master tag near to the remote
transponder reader.
• Every trhee seconds the software will
cycle through the channels that can be
associated with the new tag accompanied
by the sounding of the buzzer as follows:
3 sec 3 sec
CHA CHB
1 bip 2 bip
• Once you have chosen the channel
remove the master tag from the reader.
• Move the tag to memorise near to the
remote transponder reader.
• The interface will give confirmation by
sounding a 'beep'
3 sec 3 sec
3 sec
CHC CHD
3 bip 4 bip
5. Cancelling user codes locally
• Move jumper J5 on the interface to 'pos. 1'.
• Press and hold down the button P2 for at
least 2 seconds.
• During the procedure the red led L2 will flash
quickly.
• The buzzer B1 will sound 'beep' to confirm.
• The user code cancellation procedure will
be activated with a time out maximum of
30 seconds.
Keypad
• Type the code to be cancelled into the
keypad and press "
Transponder
DEL
• Move the tag you want to cancel near to
5 bip
the transponder reader.
• The interface will sound a beep to confirm.
The code has been cancelled
If you have inserted an invalid code or used a tag that
has not been memorised the interface will sound 5
consecutive beeps.
28
*
".