Mixing Tool Function - Robot Coupe MP 350 Turbo Manual De Instrucciones

• WHISK FUNCTION
( MP 350 Turbo Combi, MP 450 Turbo Combi,
MP 450 Turbo FW)
Attaching the whisk gearbox to the motor unit
- Unplug the power mixer.
- Align the flat side A of the conical part
whisk gearbox with the catch
B
the aluminum casing.
- Insert the conical part of the whisk gearbox
C
into the aluminum casing.
- Turn the whisk gearbox in the direction of the
arrow (see figure) until it is snugly locked into
place.
Removing the gearbox
- Unplug the power mixer.
- Turn the whisk gearbox in the opposite direction
from that used to attach it.
- When it will go no further, remove the whisk
gearbox from the aluminum casing.
Fitting the whisk into the whisk gearbox
C of the
on the inside of
- Grasp the holder in one hand.
- With the other hand, take the first whisk and
insert the shaft
gearbox drive shaft. Make sure the drive lugs
are properly aligned with the notches.
- As you push the whisk into the holder drive shaft
, rotate it slightly in order to slide the drive lugs
C
into the notches
locking the whisk into place inside the shaft.
- To check that the whisk is properly fixed inside the
shaft , gently pull the metal wires.
C
- Repeat this procedure with the second whisk. If
you cannot push it in properly, remove it, rotate it
90° and start again.
into the bore of the whisk
A B
D
of the drive shaft , thereby
D
C
Removing the whisk from the whisk gearbox
While griping the
B
ejector A in one
hand and the holder
in the other, pull
B
the ejector in the
direction of the arrow.
Removing the ejector
Hold the whisk by the
wires B
With the other hand,
pull the ejector
direction of the arrow
(see figure).

• MIXING TOOL FUNCTION

(MP 450 Turbo FW XL)
ATTACHING THE MIXING TOOL TO THE MIXING
TOOL HOUSING:
Line the flat side of the mixing tool
flat side of the housing .
A
A
in one hand.
in the
A
Mixing tool
housing
Mixing tool
up with the
B
9